Interfacing Raspberry Pi and LPC1114FN28 via SPI

In one of my previous posts, i mentioned about building a toy car project using Raspberry Pi as the brain and the LPC1114FN28 for low level control. This post describes in detail of this hobby project.

Basically, in this project, the Raspberry Pi (running a minimal version of Debian, not Rasbian) acts as a master that :

1. performs some high level calculation (software algorithm) base on the data it collects from the LPC chip (slave)
2. Issues a control command to the slave chip (LPC) for low level control
3. Reading image from Raspberry Camera for some vision stuffs
4. Takes care of network communication for remote control
5. Implements easily a lot of funny stuffs...

One question: why do not use the Pi to communicate directly with sensor or actuator ?. Although the Pi is a pretty performance system, it lacks some low level feature that we will need in this project, such as ADC for reading analog sensors, precise PWM hardware controller for motor control, etc. Therefore, i decided to used it along with the LPC chip that is more suitable for these low level stuffs.